RugDoctor Wide Track Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
Maintaining Your Rug Doctor Machine
Follow these guidelines to ensure your Rug Doctor machine will last a lifetime. Failure to comply with the instructions, cautions and safety warnings in
this manual voids the warranty
Cleaning Your Machine
Drain the machine by spraying out remaining solution over a floor drain or outdoors (never in rain or on wet ground). Do not allow machine to stand
in liquid while emptying. For best results, spray out liquid with machine set to Upholstery Hand Tool to prevent brushes from movement and wear
while emptying. Using this method you can spray out remaining liquid either through Hand Tool or machine spray tips.
Clean the vibrating brush. After each use, unplug the machine from power source and use your finger or an old comb to remove any debris from the
vibrating brush. If you used any Rug Doctor attachments, also remove debris from the attachment vacuum slot.
Clean the vacuum filter. After each use, inspect the cylindrical filter screen located inside of the clear plastic dome on the front of the machine. If
debris is present, remove the filter screen by pushing it right and compressing the spring until the filter end is clear of the dome. Clean by running
water through the screen from the inside to the outside. Replace by compressing the spring wire and inserting the black end securely into place in the
hole inside the dome.
Clean the solution tank filter screen. After each use, inspect the rectangular filter screen located in the fill opening of the solution (lower) tank. If
debris is present, remove screws that hold the filter in place and remove filter from the solution tank opening. Clean filter by holding it under a water
faucet and letting the water run through the filter in the opposite direction from the normal filling flow. Replace the filter screen and fasten it in place
with the two mounting screws.
Clean the solution tank line strainer. When the solution tank filter screen is removed for cleaning, inspect the cylindrical filter mounted on the end of
the solution line inside of the tank. The Wide Track has two cylindrical filters. If debris is present, remove the filter by pulling it off the solution line.
Hold the filter under flowing water until debris is cleared. Replace the filter by pushing it over the end of the solution hose.
Remove carpet fibers from vacuum slot. Periodically check the vacuum slot on the bottom front of the machine for debris. Remove any fiber, hair or
other debris that may be caught in the slot using a stiff wire with a hook on the end. You can use wire coat hanger. Always make sure the machine is in
the “OFF” position, unplugged and the tanks are empty
.
Caring for Your Machine
Always use recommended cleaning agents. Do not use dye or bleach in this machine.
Oil the machine. Periodically use a light lubricating oil to deter corrosion of quick-disconnect and other moving parts. Be sure to wipe all excess oil
from lubricated areas.
Store the machine indoors out of dusty, wet and freezing areas. This prolongs the life of your Rug Doctor machine and helps keep it trouble free.
Do not expose Rug Doctor machines to freezing temperatures for a prolonged period of time. In freezing temperatures, liquid in the machine system
can damage the pump and solution hoses. If you must expose the machine to temperatures at or below 32 °F (0 °C), take precautions to protect the
pump and solution hoses.
Use care when transporting your Rug Doctor machine. Rug Doctor machines are designed for rugged use. However, avoid mishandling such as
dropping the unit or transporting it in an open van or truck. Jarring from sudden vehicle starts or stops can damage the machine
.
Obtaining Service for Your Machine
Register your new carpet cleaner by completing and returning the attached Rug Doctor Product Registration Card. The registration entitles you to
service work and replacement parts during the warranty period should your cleaner need repairs.
Do not attempt repair on a machine under warranty. Servicing and warranty repairs should be performed by an authorized service representative only.
If you experience an operational problem, call our Consumer Support Hotline at 1-800 RUG DOCTOR (1-800-784-3628). Basic replacement parts
can be ordered through Consumer Support. If repair is required, you will be directed to take or ship your unit to the nearest authorized repair station.
Rug Doctor recommends you keep the original carton and packing materials.
Rug Doctor will, without charge, during the Warranty Period, repair or replace, at its option, any component part which is defective or that
malfunctions when the machine is returned within the warranty period.
When returning a machine for non-warranty or out of warranty repairs, always insure the carpet cleaner for its full value before shipping.
The warranty entitles the owner of a Rug Doctor machine to specific legal rights. You also may have other rights. Rights vary state to state.
Rug Doctor’s liability is limited to the cost of the unit. Some states do not allow the exclusion or limitation of incidental or consequential damages, so
this limitation or exclusion may not apply to you. If you have questions about your warranty, please call Rug Doctor at 1-800 RUG DOCTOR.
71239B_MP-WT_WMT-Manual.qxp 9/21/09 4:09 PM Page 8
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire